Product Overview
Majestic 42-inch Meridian Modern Direct Vent Gas Fireplace MER42MN provides 18,000–36,000 BTU/hr natural gas. Natural gas only; propane is not available. This indoor fireplace uses IntelliFire Touch intermittent-pilot ignition and a sealed direct-vent system. The contemporary firebed uses separately ordered approved crushed glass, with optional decorative stones or driftwood.
Create an inviting place where the best moments begin with the big, bold and comfy Meridian gas fireplace. Gather 'round dancing flames and warm up with generous heat. Even run your fireplace with a smart speaker. With on-trend styling to fit your look, it will be your favorite spot in the home.
Features
- 18,000 - 36,000 Btu/Hour Input (NG)
- Ceramic glass
- 12 ft wall switch wire
- 2 sided black ceramic glass liner
- Battery backup
- IntelliFire Touch Ignition System
Special Considerations:
- Flame adjustment requires RC400 or IFT-WFM
- STONES-NATURAL: 3 bags (must use with crushed glass media)
- Please note: LP is not available for this fireplace
Required to Complete - Sold Separately:
- Front
- Approved crushed glass: purchase three 5 lb bags; the installation table specifies 2-1/2 bags (12-1/2 lb). Do not install all 15 lb.
Requires 8" DVP pipe.
Approved for use with SLP pipe. Restrictions apply. See Installation manual for venting specifications.
Approved for use with PVLP-SLP, PVI-SLP-B and PVV-SLP with power vent wire harness and IFT-RC400 remote (order
separately). See venting section of manual.
Specifications
| Model | Meridian 42 Modern |
|---|---|
| Framing Width | 49" |
| Framing Depth | 22" |
| Framing Height | 42-1/8" |
| BTU/hr Input | 36,000 (NG) — natural gas only |
| Viewing Area | 41 1/4 x 26 11/16" |
Service Parts
Architect Guides
CAD Drawings
Accessory Manuals
Model-specific installation details
| Appliance dimensions (W × H × D) | 48-1/16 × 42-7/8 × 21-7/16 inches |
|---|---|
| Minimum rough opening (W × H × D) | 49 × 42-1/8 × 22 inches; adjust for chase sheathing |
| Viewing area (W × H) | 41-1/4 × 26-11/16 inches |
| Appliance weight | 190 pounds; packaged shipping weight is not stated here |
| Glass | Ceramic |
| Venting | Top vent; minimum 6-inch vertical rise before the first 90-degree elbow; use the exact approved DVP/SLP configuration in the installation manual |
Required and optional selections
A model-compatible decorative barrier front is required and ordered separately. Operate only with the glass assembly and barrier correctly installed. Approved crushed glass is required: 2-1/2 five-pound bags (12-1/2 lb); purchase three bags and retain the excess. Mixed approved colors must be mixed before placement. Spread only the prescribed thin layer, leave the pilot-protection area clear and follow the placement diagram. Optional STONES-NATURAL uses three bags and the supplied positioning jig; stones do not replace the required glass. A compatible remote, fan and Wi-Fi control are optional accessories unless a chosen powered-vent configuration specifically requires additional controls.
Installation and ownership
This is supplemental room heat, not a primary whole-home heating system. Plan the vent route, approved termination, gas connection, electrical supply and required barrier before ordering. Minimum side and rear clearance is 1/2 inch; keep 36 inches clear in front. Mantel, ceiling, finishing-material and optional heat-management clearances depend on the exact installation; use the manual diagrams. Installation and service must follow manufacturer documentation and applicable codes.
Hearth & Home Technologies provides a component-specific limited warranty subject to its conditions, exclusions and coverage periods. Review the current owner manual warranty rather than assuming every component has lifetime coverage.
