Empire DVP4SA Aged Brick Liner for DVD48 Fireplace

The DVP4SA simulated-brick liner gives the DVD48 gas fireplace an aged brick interior appearance. Empire lists this exact liner as an optional decorative accessory for the DVD48; it is not a required burner, log set or venting component.

Identity and compatibility

• Manufacturer part number: DVP4SA.
• Documented fireplace: Empire DVD48 models covered by manual 43115-3-1024.
• Pattern: Aged Brick.
• Product type: optional interior simulated-brick liner.
• The fireplace, burner and other separately listed accessories are not included.

Installation details

The manufacturer installation sequence requires access through the fireplace glass-frame opening and removal of the rear logs before positioning the rear and side panels. Align the brick joints, secure the top panel using the designated holder tabs, and reinstall the logs in their prescribed positions before replacing the glass frame and louvers. The rear panel relief must align with the rear flue opening. A qualified installer should follow the complete illustrated instructions; preserve all original clearances, glass seals, safety barriers and service access.

Selection guidance

This liner is an optional appearance choice. It does not replace a required fireplace safety barrier or change the fuel configuration, heat input, vent system or framing requirements. Match the exact fireplace model before ordering; a similar nominal width is not proof of fit.

Manufacturer documentation

Empire DVD installation and owner manual 43115-3-1024: optional liner installation page 62 and exact model accessory table page 63. Installation must comply with the complete appliance manual and applicable codes.